1010 Battery Pack; 1020 Hard Disk Drive (Hdd) Cover, Hdd, And Hdd Rubber Rails Or Solid State Drive (Ssd) And Storage Converter - Lenovo ThinkPad X200 Hardware Maintenance Manual

1010 Battery pack

Important notice for replacing a battery pack:
The Lenovo ThinkVantage Toolbox (in Windows 7), Lenovo System Toolbox (in Windows Vista and Windows
XP), and Lenovo Solution Center (in Windows 7) have an automatic battery diagnostic that determines if
the battery pack is defective. A battery pack FRU should not be replaced unless this diagnostic shows
that the battery is defective.
The only exception to this is if the battery pack is physically damaged or a customer is reporting a possible
safety issue.
If ThinkVantage Toolbox or Lenovo System Toolbox is not installed in the computer, the customer should
download this program before a non-physically damaged battery pack is replaced. Note that a physically
damaged battery pack is non-warranty replacement.
Table 9. Removal steps of battery pack
DANGER
Use only the battery specified in the parts list for your computer. Any other battery could ignite or explode.
Unlock the battery release lever
pack in the direction shown by arrow
When installing:
Install the battery pack along the slide rails of the slot. Then make sure that the battery release lever is in the
locked position.
1020 Hard disk drive (HDD) cover, HDD, and HDD rubber rails or solid
state drive (SSD) and storage converter
For access, remove this FRU:
• "1010 Battery pack" on page 71
Downloaded from LpManual.com Manuals
1
. Holding the battery release lever in the unlocked position
3
.
1 2
3
.
Chapter 8 Removing and replacing a FRU
2
, remove the battery
71