Sharp ER-04RP Service Manual page 47

13)
14)
15)
16)
17)
18)
19)
20)
21)
Connectthe SRN cable@.
Connect the AC cord.
Attach the holder @ to the AC cord @.
Fix the holder @ to the cable angle@ with a screw @.
Remove the four screws @ suited the back cover@.
Fix the two wall fitting angle B @ to the back cover@ with four
screws @.
Replace the back cover @ to the ER-04RP withfourscrews@.
P
-4
L
17
Fig. 4
Remove the operation panel @ and take off the adhesive on the
upper cover @.
Replace the wall fittingoperationpanel @ and attach the printer
cover@ to
ER-04RP.
22)
Attach the wall fittingangle A@ to the wall.
Tghten the six screwsto fix the wall fittingangle A.
The six screws are not included in the wall fitting kit, use
mmmercially availableones whichhave enoughstrengthand
are mode of suitablematerial.
* When selecting the place of installing the printer unit, con-
sider well its weight, how much it vibrates during operation,
and the environmentalconditionssuch as ambient tempera-
ture and humidity.
And the place is the ER-04RP don't drop out of wall when
personlean againsta wall.
23) Hang the ER-04RP on the wall fitting angle A@.
Fig. 6
P
20
Operation panel
@ Printer
<v
/
cover
Fig. 5
-45-