Sharp ER-04RP Service Manual page 46

2)
3)
4)
5)
6)
ER-04RP
Remove the four screws @ suited on the back cover@.
7)
Remove the back cover @.
8)
Remove the screw @ and connector cover@.
9)
Remove the connector guide @ and SRN connector cable @ in
the direction of arrow ~.
10)
SRN connector cable @ is rather long, pull out the cable when
removing.
11)
Loosen the fixing nut of SRN connector cable @, and remove it
from connector angle @.
12)
Return connector guide @ to the original position.
Pass the SRN connector cable @ through bottom base@.
Hang the bottom base @ to the ER-04Rp in the direction of
arrow D.
Fix the bottom base @ to the connector guide @ with the screw
@.
Fix the SRN connector cable @ to cable angle @ with a fixing
nut.
Fix the cable angle @ to the connector guide @ with two
screws.
~~ Screw(M3 x 6)
Fig.2
Fig. 3
-44-