GoPro HERO+ User Manual page 20

/ Settings
SPOT METER
Spot Meter is good for filming into a setting where the lighting is
different from where you are, such as filming the outdoors from within
a car or filming a shaded environment while standing in the sun. Spot
Meter automatically sets the exposure based on a single spot in the
middle of the image. When Spot Meter is turned on, [
on the camera displays. The options for this setting are Off (default)
and On.
Note: Changes that you make to the Spot Meter setting in Video mode apply only to video capture.
To adjust this setting for another mode (Photo, Burst, or Time Lapse), adjust the setting within
that mode.
38
] appears
INTERVAL
In Video mode, this setting applies only to Looping. Looping lets you
continuously record and save only the best moments, which helps to
conserve space on your microSD card. Available intervals for looping
are 5, 20, 60, and 120 minutes. For example, if you select a 5-minute
interval, the previous 5 minutes are saved when you stop recording.
You can also select Max as the interval for Looping. With this option,
the camera records until the memory card is full, then overwrites the
content. The default option for Looping is Off.
Note: To use Looping, be sure that your microSD card has sufficient space to create the loop segment
based on the interval that you select. If the microSD card becomes full, Looping does not overwrite
the content.
PRO TIP: Files are written to your memory card in segments. When
viewing this content on a computer, you might see separate files for
each time segment. Use GoPro Studio software to combine the files
into a longer video.
/ Settings
39