OPERATING PROCEDURE
2. Removing the indoor fan motor
(1) Remove the grille. (Refer to 1(1) (2).)
(2) Remove the fan casing.(upper)
(3) Disconnect the connector of the indoor fan motor.
(4) Disconnect the ground wire of the fan motor.
(5) Remove the screws of the motor band and remove the
catch.
(6) Take out the sirocco fan and the indoor fan motor.
3. Removing the indoor heat exchanger.
(1) Remove the grille. (Refer to 1(1) (2).)
(2) Remove the screws on both side and in front of the front
panel. (Photo 5)
(3) Remove the screws of the nozzle assembly. (Photo 6)
(4) Remove the electronic box. (Refer to 1.)
(5) Remove the indoor fan motor. (Refer to 2.)
(6) Remove the screws of the motor support .
(7) Remove the fan casing. (Iower)
(8) Remove the insulation of the drain pan and remove the
screws. (Photo 7)
(9) Remove the screws under the drain pan. (Photo 8)
(10) Remove the drain pan.
(11) Remove the indoor heat exchanger.
Photo 6
Photo 4
Indoor fan motor
Photo 5
Screws
Photo 7
Screws
Photo 8
20
PHOTOS
Motor band
Fan casing
(upper)
Screws
Insulation and screws
screws
Fan
casing(upper)