Vertex Standard eVerge EVX-Link Faqs

EVX-Link
IP Connect System
FAQs
EVX-Link
How much bandwidth does the EVX Link require on a network?
1M bps
Is there a minimum network speed required or how does the
EVX Link manage the latency on a slower network (ex. satellite)?
min 256k bps for 2 sites.
IS the DB15 audio port active?
We do not use audio input/output on the DB15.
Can I walk into a customer's office and just plug their Lan cord
into the box and demo the EVX link or do I need to configure the
box every time?
The box will need to be configured/reprogrammed to include the
IP information of the new site.
What is the speed requirement for the IP address?
It is recommended to operate at 8M bps at least.
Can I demo this box with a wireless card, if so how?
It requires other hardware that can specify the connected IP
address to the EVX-Link. The equipment setting is depending on
that equipment.
Can EVX Link be used in a router configuration?
Yes, it can be used for the router. When using a router, the network
address and port translation (NAPT) is necessary. The following
UDP (user datagram protocol) port must be connectable (21000).
Is it possible to demo easily in the field - How to set up
The easiest way is that to use the HUB to connect each EVX-Link.
The EVX-Link must setup to connect each other.
How does Link work in a LAN environment?
It transfers the DMR data to the other site using UDP protocol.
Will the EVX-Link work in a Analogue mode via the EVX-5400
Mobile as it is this device that is putting the signal into the
EVX-Link as the Mobile supports DMR and Analogue modes.
No, the EVX-Link only work for Digital mode.