Advertisement
feature is enabled. The callsign field may contain up to 16 characters.
Here's how to program the CW Identifier:
1.
Press and hold the [H/L] key for one second to enter the Set mode.
2.
Rotate the DIAL knob to select the Set Mode Item 39: CW ID.
3.
Press the [H/L] key momentarily to enable adjustment of the selected Menu Item.
4.
Rotate the DIAL knob to select ON (to enable the CW ID function).
5.
Press the [MH/RV] key momentarily to clear any previous callsign.
6.
Rotate the DIAL knob to select the first letter/number of your callsign, then press
the [V/M] key momentarily to save the first letter/number and move on to the next
character.
7.
Repeat the previous step as necessary to complete your callsign. Note that the
"slant bar" (– • • – •) is among the available characters, should you be a "portable"
station.
8.
If you mistake, press the [BAND] key to back-space the cursor, re-enter the correct
letter/number.
9.
Press the [HM/RV] key to delete all data after the cursor that may have been
previously stored erroneously.
10. When you have entered your entire callsign, press the [H/L] key momentarily to
confirm the callsign, then press the PTT key to save the settings and exit to normal
operation.
R.F. Says: You may check your work by monitoring the entered callsign. To do this,
repeat steps 1- 3 above, then press the [MON/F] key.
DTMF Operation
Despite the lack of a DTMF keypad, you can still transmit DTMF tones with the VX-2R
for repeater control or autopatch use.
Manual DTMF Tone Generation
DTMF Autodialer
Nine DTMF Autodial memories are provided, allowing you to store telephone numbers
for autopatch use. You can also store short autopatch or Internet-link access code
streams so as to avoid having to send them manually.
Here is the DTMF Autodial storage procedure:
VX-2R O
19
FCC ID: K66VX-2R
M
PERATING
ANUAL
Vertex Standard Co., Ltd.
Advertisement
