Tread Depth - Chevrolet Cruze Owner's Manual

274 Vehicle care
wheel positions. If it takes longer, the
matching process stops and must be
restarted.
The TPMS sensor matching process
is:
1. Set the parking brake.
2. Turn the ignition to ON/RUN with
the engine off.
3. Use the MENU button to select
the Vehicle Information menu in
the Driver Information Centre
(DIC).
4. Use the thumbwheel to scroll to
the Tyre Pressure Menu item
screen.
5. Press the SET/CLR button to
begin the sensor matching
process. A message requesting
acceptance of the process should
display.
6. Press the SET/CLR button again
to confirm the selection. The horn
sounds twice to signal the
receiver is in relearn mode and a
message indicating that the
matching process is active
displays on the DIC screen.
7. Start with the driver side front tyre.
8. Place the relearn tool against the
tyre sidewall, near the valve stem.
Then press the button to activate
the TPMS sensor. A horn chirp
confirms that the sensor
identification code has been
matched to this tyre and wheel
position.
9. Proceed to the passenger side
front tyre, and repeat the
procedure in step 8.
10. Proceed to the passenger side
rear tyre, and repeat the
procedure in step 8.
11. Proceed to the driver side rear
tyre, and repeat the procedure in
step 8. The horn sounds two times
to indicate the sensor
identification code has been
matched to the driver side rear
tyre, and the TPMS sensor
matching process is no longer
active. The message indicating
that the matching process is
active on the DIC display screen
goes off.
12. Turn the ignition to LOCK/OFF.
13. Set all four tyres to the
recommended air pressure level
as indicated on the tyre pressure
label 3 270.

Tread depth

Check tread depth at regular
intervals.
Tyres should be replaced for safety
reasons at a tread depth of 2-3 mm
(4 mm for winter tyres).
For safety reasons it is recommended
that the tread depth of the wheels on
one axle should not vary by more than
2 mm.