Oki B6200 Maintenance Manual page 282

Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/PL9.1.12). (RRP10.9/9.4)
2) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
3) Remove the COVER REAR (PL1.1.3). (RRP1.1)
4) Remove the FAN MAIN (PL12.1.10). (RRP12.6)
5) Remove the CHUTE TRANSFER (PL8.1.22) together with the BTR ASSY. (RRP8.11)
6) Disconnect the connector (P/J245) of the HARNESS ASSY TRAY 1 (PL5.1.37) from the HAR-
NESS ASSY CHUTE (PL12.1.17).
7) Disconnect the connector (P/J221) of the HARNESS ASSY TONER 1 (PL5.1.50) from the HAR-
NESS ASSY TONER 2 (PL12.1.28).
8) Remove the 5 screws (silver with flange, 8mm) securing the 150 FEEDER ASSY to the printer.
9) Shift the 150 FEEDER ASSY backward, and remove the right boss of the 150 FEEDER ASSY
from the frame.
10) Lift up the 150 FEEDER ASSY in the direction of the arrow (A), and remove the left boss of the 150
FEEDER ASSY.
Althrough the 150 FEEDER ASSY clicks into midway when lifted up, push it a little
bit further.
11) Remove the 150 FEEDER ASSY from the printer.
Replacement
1) While lifting up the 150 FEEDER ASSY in the direction of the arrow (A), and install it to the printer.
Then, iput the bosses at right and left of the 150 FEEDER ASSY into the holes of the printer.
2) Secure the 150 FEEDER ASSY to the printer using the 5 screws (silver with flange, 8mm).
One of the screws that secure the 150 FEEDER ASSY is tightened together with the
EARTH PLATE BASE (PL5.1.27).
3) Connect the connector (P/J221) of the HARNESS ASSY TONER 1 (PL5.1.50) to the HARNESS
ASSY TONER 2 (PL12.1.28).
4) Connect the connector (P/J 245) of the HARNESS ASSY TRAY 1 (PL5.1.37) to the HARNESS
ASSY CHUTE (PL12.1.17).
5) Install the CHUTE TRANSFER (PL8.1.22) together with the BTR ASSY to the printer. (RRP8.11)
Do not tighten the screw to the left side hole of the CHUTE TRANSFER.
6) Install the FAN MAIN (PL12.1.10). (RRP12.6)
7) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
8) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
9) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/PL9.1.12). (RRP10.9/9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 118