Kenwood TS-590S Reference Manual page 27

SS
Sets and reads the Program Slow Scan frequency.
1 2 3
S S P1
Set
11 12 13
P3 P3 P3
1 2 3
Read
S S P1
1 2 3
S S P1
Answer
11 12 13
P3 P3 P3
PC Control Command referenCe guide
4 5 6 7 8
P2 P3 P3 P3 P3
14 15 16 17 18
P3 P3 ;
4 5 6 7 8
P2 ;
4 5 6 7 8
P2 P3 P3 P3 P3
14 15 16 17 18
P3 P3 ;
[TS-590S / TS-590SG common]
Parameters:
9 10
P1
0 ~ 9: Memory channel number for Program Slow Scan
P3 P3
P2
19 20
0 ~ 4: Slow down frequency spot
P3
Slow down frequency (11 digits in Hz)
9 10
• If no point frequency has been set, parameter P3 is all 0's.
• If parameter P3 is set to all 0's, the point frequency set for
9 10
parameter P2 is deleted.
• Other than when deleting parameter P3, you cannot set a
P3 P3
frequency exceeding the section selected channel lower/upper
19 20
frequency limits.
• If a P2 parameter is skipped (not entered sequentially from 0 to
4), the parameter will not be accepted.
• If the specified P1 parameter is an empty Memory channel, the
SS command becomes invalid.
• When the AI function is ON, all slow scan points of the current
Memory channel are output.
• When the AI function is ON and the status of the slow scan
points changes (newly registered or deleted points), all slow
scan points are output.
• In each section selected channel, when multiple slow scan point
frequencies are set up, if you delete a frequency from one of the
slow scan point numbers, the remaining point frequencies are
renumbered with slow scan point numbers, starting from 0.
Example:
The following table lists point numbers and their respective
frequency settings, before deleting any frequencies.
Slow Scan Point Number
(P2)
0
1
2
3
4
If Slow Scan Point number 1 is deleted, numbers 2 ~ 4 step up
one spot to fill in spots 1 ~ 3, leaving spot 4 empty.
Slow Scan Point Number
(P2)
0
1
2
3
4
The Slow Scan Point frequencies following the deleted point are
read, and the empty point is written as a space (the frequency is
not set).
– 26 –
Slow Scan Point Frequency
(before deletion)
14.0 (MHz)
14.1 (MHz)
14.2 (MHz)
14.3 (MHz)
14.35 (MHz)
Slow Scan Point Frequency
(after deletion)
14.0 (MHz)
14.2 (MHz)
14.3 (MHz)
14.35 (MHz)
Empty