Headlight Beam Adjustment - Polaris RANGER RZR XP 900 Owner's Manual For Maintenance And Safety

MAINTENANCE
Lights

Headlight Beam Adjustment

The headlight beam can be adjusted slightly upward or downward and
to the left or right.
1. Position the vehicle on a level surface. The headlight should be
approximately 25 ft. (7.6 m) from a wall.
2. Place the transmission in PARK.
3. Measure the distance from the floor to the center of the headlight
and make a mark on the wall at the same height.
4. Apply the brakes. Start the
engine. Turn the headlights to
high beam.
5. Include the weight of a rider on
the seat while performing this
step. Observe the headlight
aim. As a starting point, the
most intense part of the head-
light beam should be 2 inches
(5 cm) below the mark on the
wall. Adjust to operator prefer-
ence.
6. Tighten or loosen the three (3)
headlight screws to adjust the
beam upward or downward or
to the left or right.
108
X
25 ft.
(7.6 m)
Adjustment
Screws
X
2 in. (5 cm)