Table of Contents
Advertisement
RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE
• Hot! Do not touch! The glass and
surfaces of this appliance will be hot
during operation and will retain heat
for a while after shutting off the appli-
ance. Severe burns may result.
• Carefully supervise children in the
same room as appliance.
• If small children are present in the home, it is
recommended that this appliance be fi tted with
a screen door or screen panel kit. See Pages
18 & 19 for ordering information.
WARNING: IF THE INFORMATION IN THIS MANUAL
IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLO-
SION MAY RESULT CAUSING PROPERTY DAMAGE,
PERSONAL INJURY OR LOSS OF LIFE.
FOR YOUR SAFETY: Do not store or use gasoline
or other fl ammables or liquids in the vicinity of
this or any other appliance.
FOR YOUR SAFETY: What to do if you smell gas:
• DO NOT light any appliance.
• DO NOT touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow your gas suppliers
instructions.
• If your gas supplier cannot be reached, call
the fi re department.
Installation and service must be performed by
a qualifi ed installer, service agency or the gas
supplier.
WARNINGS
OTL Report No. 116-F-36-5
HOMEOWNER'S CARE AND
OPERATION INSTRUCTIONS
B-VENT
MPB-33/35/40/45 SERIES
B-VENT GAS FIREPLACES
P/N 875,031M REV. B 05/2006
MODELS
Millivolt Models
MPB3530CPM
MPB3328CNM
MPB4035CNM
MPB3328CPM
MPB4540CNM
MPB3530CNM
A French manual is available upon request. Order P/N 875,031CF
Ce manuel d'installation est disponible en francais, simplement en
faire la demande. Numéro de la pièce 875,031CF.
AVERTISSEMENT: ASSUREZ-VOUS DE BIEN
SUIVRE LES INSTRUCTIONS DONNÉ DANS CETTE
NOTICE POUR RÉDUIRE AU MINIMUM LE RISQUE
D'INCENDIE OU POUR ÉVITER TOUT DOMMAGE
MATÉRIEL, TOUTE BLESSURE OU LA MORT.
POUR VOTRE SÉCURITÉ: Ne pas entreposer ni
utiliser d'essence ni d'autre vapeurs ou liquides
infl ammables dans le voisinage de cet appareil ou
de tout autre appareil.
POUR VOTRE SÉCURITÉ: Que faire si vous sentez
une odeur de gaz:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur. Ne pas vous
servir des téléphones se trouvant dans le bati-
ment où vous vous trouvez.
• Evacuez la piéce, le bâtiment ou la zone.
• Appelez immédiatement votre fournisseur de
gaz depuis un voisin. Suivez les instructions
du fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de
gaz, appelez le service dos incendies.
L'installation et service doit être exécuté par un
qualifi é installeur, agence de service ou le fournis-
seur de gaz.
Electronic Models
MPB3328CNE
MPB4035CNE
MPB3530CNE
MPB4540CNE
Advertisement
Table of Contents
Related Manuals for Lennox Hearth Products MPB-33
Summary of Contents for Lennox Hearth Products MPB-33
-
Page 1: Operation Instructions
Installation and service must be performed by a qualifi ed installer, service agency or the gas supplier. OTL Report No. 116-F-36-5 HOMEOWNER'S CARE AND OPERATION INSTRUCTIONS B-VENT MPB-33/35/40/45 SERIES B-VENT GAS FIREPLACES P/N 875,031M REV. B 05/2006 MODELS Millivolt Models MPB3530CPM MPB3328CNM... -
Page 2: Safety & Warning Information
SAFETY & WARNIING INFORMATION IMPORTANT: PLEASE READ THIS MANUAL IN ITS ENTIRETY AND UNDERSTAND THESE RULES TO FOLLOW FOR SAFETY. WARNING If the information in this manual is not followed exactly, a fi re or explo- sion may result caus- ing property damage, personal injury or loss of life. -
Page 3: Table Of Contents
CONGRATULATIONS! In selecting this Lennox B-Vent Gas Appliance you have chosen the fi nest and most dependable fi replace to be found anywhere. A beautiful, prestigious, alternative to a wood burning fi replace. Welcome to a Family of tens of thousands of satisfi ed Lennox Fireplace Owners. -
Page 4: Operation/Care Of Your Appliance
The appliance must be isolated from the gas supply piping system (by closing its individual manual shut-off valve) during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3.5 kPa). The appliance and its individual shut-off valve must be disconnected from the gas supply piping system during any pressure testing of that system... -
Page 5: Outside Combustion Air Control
Variable Flame Height Adjustment Manifold Pressure Port Piezo Igniter Figure 3 3. Keep lower control compartment clean by vacuuming or brushing at least twice a year. More frequent cleaning may be required due to excessive lint from carpeting, bedding materials, etc. -
Page 6: Manual Limit Switch
WARNING Do not operate the shutoff lever unless a complete outside combus- tion air system has been installed with your appliance. To open the outside air shutter, open the bottom control access panel, reach into control com- partment and pull the combustion air control lever all the way out. -
Page 7: Maintenance Schedule
MAINTENANCE SCHEDULE - Annually (Before the onset of the Burning Season) MAINTENANCE TASK Inspecting/Cleaning Burner, Logs and Controls Check Flame Patterns and Flame Height Inspecting/Cleaning Pilot and Burner Checking Vent System Appliance Checkout Replacing Rockwool Ember Materials MAINTENANCE SCHEDULE - Periodically (After the Burning Season) MAINTENANCE TASK Cleaning Firebox Interior... -
Page 8: Maintenance
Wire Termianls Cabinet Corner Back Of Limit Switch Door Frame Detail A Lintel Securing Screw Hole in Cabinet Top Fire Box Top Scoop Scoop Securing Screws Detail B Lintel Securing-Screw Fire Box Top Hole in Cabinet Top Limit/Bracket Securing Screws Limit Detail C Blocked Flue Safety Limit Location... -
Page 9: Burner Adjustments
Burner Adjustments Note - The air shutter for the burner primary air opening is factory-set. Do not adjust the factory-set position. The factory-set position is shown in Figure 7. Burner Air Shutter Adjustment Ref. Air shutter Patent: U.S. Pat. 5,553,603 Main Burner Factory Air Shutter Opening Setting - Inches (millimeter) Model... -
Page 10: Volcanic Stone Placement
Log Placement WARNING Logs get very hot and will remain hot up to one hour after gas supply is turned off. Handle only when logs are cool. Turn off all electricity to the appliance before you install grate and logs. WARNING This appliance is not meant to burn wood. - Page 11 Glowing Embers, Vermiculite, Decorative Volcanic Stone And Log Placement Instructions: Step 1. Separate the Glowing Embers (Rockwool) into pieces about the size of a quarter (see Figure 13). Keep the pieces fl uffed up, not matted. MPB-3328 & MPB-3530 Models - Distribute these pieces over the burner as shown in Figure 14.
- Page 12 Figure 16 MPB-3328 LOG PLACEMENT Position the individual logs as shown below. Logs should be placed in the order shown. Position the rear log on the brackets at the rear of the fi rebox with the log's notches directly over the brackets. Position the right log (log no.
- Page 13 Figure 17 MPB-3530 LOG PLACEMENT * Item * Item numbers above correspond to photos Position the individual logs as shown below. Logs should be placed in the order shown. Position the rear log on the brackets at the rear of the fi rebox with the log's notches directly over the brackets. Position the right log (log no.
- Page 14 Figure 18 MPB-4035 & MPB-4540 LOG PLACEMENT * Item numbers above correspond to photos Position the individual logs as shown below. Logs should be placed in the order shown. Position the center log on the burner fi rst, then place the glowing embers as shown in Fig- ure 15.
-
Page 15: Wiring Diagrams
WIRING DIAGRAMS Wiring diagrams are provided here for reference purposes only. This information is also provided on schematics attached directly to the appliance on a pullout panel located within the control compartment. CAUTION: LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DAN- GEROUS APPLIANCE OPERATION. -
Page 16: Accessory Components
ACCESSORY COMPONENTS Remote Control Kit, Standard Cat. No. Model No. Description H0249 Remote Control System (Standard) Standard Remote Control System The Model RCL (Standard) Remote Control System, features a simple On/Off control function for the fi re- place. This model includes a hand-held transmitter, a remote receiver with wall-mount cover plate and all hardware required to install the unit. - Page 17 ACCESSORY COMPONENTS Arch Door Kit - Polished Brass Cat. No. Model Models-Where Used 98L05 ADK33CPB MPB-3328 26M43 ADK35CMPB MPB-3530 81L35 ADK40CPB MPB-4035 81L36 ADK45CPB MPB-4540 Arch Door Kit - Brushed Stainless Steel Cat. No. Model Models-Where Used 98L62 ADK33CBS MPB-3328 26M44 ADK35CMBS MPB-3530...
- Page 18 ACCESSORY COMPONENTS ARCH DESIGN SCREEN DOOR KITS Cat. No. Model Description H0858 AD35C 35” Arch Doors, Charcoal H0859 AD35TI 35” Arch Doors, Textured Iron H0860 AD35SP 35” Arch Doors, Satin Pewter H0861 AD35AB 35” Arch Doors, Antique Brass H0862 AD40C 40”...
- Page 19 Decorative Arch Screen Panel Kit This easy to install optional screen installs over the standard glass enclosure panel to prevent direct contact with the hot glass surface. These screen panels cannot be used in conjunction with the arch door kits or door frame kits. Decorative Arch Screen Panel Kit Cat.
-
Page 20: Lighting Instructions - Millivolt
LIGHTING INSTRUCTIONS – SIT MILLIVOLT GAS VALVE WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted with a piezo igniter. - Page 21 INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT SIT POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT : SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A.
-
Page 22: Lighting Instructions - Electronic
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. When lighting the appliance, follow these instructions exactly. B. BEFORE OPERATING smell all around the appliance area for gas. - Page 23 INSTRUCTIONS D’ALLUMAGE — ELECTRONIC POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT: SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A.
-
Page 24: Troubleshooting Guide - Millivolt
Note: Before troubleshooting the gas control system, Ensure external gas shut off valve, located at gas supply inlet, (and wall switch, iff applicable), is in the “ON” position. Important: Valve system troubleshooting should only be accomplished by a qualifi ed service technician. TROUBLESHOOTING GUIDE - MILLIVOLT GAS CONTROL SYSTEM SYMPTOM 1. - Page 25 TROUBLESHOOTING PROCEDURE - ELECTRONIC IGNITION SYSTEM START • Turn Off Gas Supply. • Ensure Valve Switch Is In ON Position. • Disconnect Control Harness. • Turn On Optional Remote Switch (if applicable) Insert A End View of Control Harness Connector 24 Volt 24 Volt Hot Common...
-
Page 26: Replacement Parts List
REPLACEMENT PARTS LIST Item # Description Hood, Charcoal Louver Assembly, Top Panel Louver Assembly, Lower Panel Enclosure, Glass Front (Complete) Nameplate, Lennox (logo) Latch Catch, Door, Magnetic Log Set (Complete) Burner Assembly Grate Assembly Orifi ce, Main Burner - Natural Gas Orifi... - Page 27 REPLACEMENT PARTS 40/45 33/35 40/45 33/35 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Located Inside Located Inside (see Figure 8) (see Figure 5 on Page 8)
- Page 28 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifi cations, prices and also to discontinue colors, styles and products. Consult your local distributor for fi replace code information. Printed in U.S.A. © 2005 by LENNOX HEARTH PRODUCTS P/N 875,031M REV.