Table of Contents
Advertisement
(2) Press [Yes] button.
(3) Input file name and press [Open] button.
1-4 Set the shading data to the projector
(1) Select [set] from [Projector] menu.
(2) Select commucation port and press [Go] button.
(3) If you save data to the projector press [Yes] button.
2. When LCD Panels are exchanged.
Step1. Adjust the VCOM data (front and celing) .
This adjustment makes the flicker of a panel into
the minimum.
Step2. Adjust the Shading data.
Step3. Set the new data to the Projector.
2-1 Adjust the VCOM data
(1) Select [Built in Signal] from [Check] menu.
This menu can output the signal pattern built
in the projector.
(2) Set the color level and press [OK] button
(When you adjust Red VCOM, set red level 100%.)
After setting press [Close] button.
(3) Select [Vcom] from [Check] menu.
1-35
Advertisement
Table of Contents
