Sony MDS-JA20ES Service Manual page 17

TRAY ASS'Y
8 Remove the tray assembly
in the arrow direction B .
• NOTE FOR INSTALLATION
slider assembly
When attaching the tray assembly, first move the slider
assembly in the arrow direction B and set pin at the
position shown.
When attaching gear (top) (two in front),
pull the tray assembly in the arrow direction A
completely, and position racks (L), (R) and
slider (D) assembly as shown in the figure.
2 two screws
(P2.6 × 6)
4 three gears
(top)
B
1 Rotate the pully gear in the arrow
direction A , and pull out the tray
assembly.
pin
rack (L)
gear (top)
3 bracket (top)
A
marking
slider (D)
assembly
– 17 –
2 two screws
(P2.6 × 6)
5 screw
(P2.6 × 6)
7 shaft
4 three gears
(top)
slider assembly
B
A
6 stopper
(shaft B)
slider (D)
assembly
tray
assembly