Using The Remote Terminal - Panasonic PT-L6600E Operating Instructions Manual

Using the remote terminal

Using the remote terminal built into this projector, it is possible to operate the projector from an external location
from where infrared remote control signals cannot be received, by using a remote control panel.
Example of a control panel layout
Projector set up in a meeting room
Pin assignment and control
Short pin 1 and pin 9 when controlling.
D-Sub 9-pin (female)
external appearance
Note
• The "POWER", "RGB" and "VIDEO" buttons on the remote control and projector will not operate when pins
1 and 9 are shorted. RS-232C commands will also be ignored.
• Do not short pins. 1, 2, 3, 5 or 6 when pin 9 is open. If this is done, the projector will ignore signals from the
remote control.
Pin No. Name
Remoto terminal ON / OFF
Lamp
RGB/VIDEO
Switch input modes
Switch DVI modes
OFF
Remote terminal ON / OFF
STANDBY
LAMP
RGB
RGB/VIDEO
VIDEO
RGB1
INPUT SELECT
VIDEO
RGB
DVI switch
Control panel located in a different room
Description
Short with pin
On
On
VIDEO
S-VIDEO (When is VIDEO)
(When is RGB)
RGB2
DVI
(When is RGB)
ON
ON
VIDEO/
S-VIDEO
S-VIDEO
RGB2
DVI
Open
Off
Off (standby)
RGB
VIDEO (When is VIDEO)
(When is RGB)
RGB1
VIDEO (When is VIDEO)
(When is RGB)
RGB
39