Wheeled Output Stacker - Canon iPF815 User Manual

Wheeled Output Stacker

An output stacker with casters, positioned in front of the printer.
a. Output Stacker
A cloth tray that catches ejected documents.
The Output Stacker can be opened and closed using the rod in front.
b. Output Stacker Ejection Guides
Prevent printed documents from winding around the Roll Holder or being drawn into the Paper Feed Slot.
Hold the Wheeled Output Stacker by these guides when moving it.
c. Output Stacker Foot Stand
Equipped with casters to facilitate moving it.
d. Stopper
Locks the Stand casters.
Always release the Stopper before moving the printer. Moving the printer while the Stopper is locked may scratch
the casters or the floor.
Note
• For instructions on assembling the Wheeled Output Stacker, see the setup guide provided with the
Wheeled Output Stacker.
• The printer can be used with either a Stationary Output Stacker or a separate, mobile Wheeled Output
Stacker.
The Wheeled Output Stacker is normally provided as an optional accessory, but it may be the standard
stacker in some sales regions. If the Wheeled Output Stacker has been provided as the standard stacker,
the Stationary Output Stacker is not included.
For more information about the Stationary Output Stacker, see "Stationary Output Stacker."
Using the Wheeled Output Stacker
Positioning the Wheeled Output Stacker by the printer will prevent rolls from dropping on the floor after printing.
The stacker is equipped with casters to facilitate moving it.
Important
• The Output Stacker can accommodate one sheet. When printing multiple pages, remove each sheet after
it is printed.
iPF815
Handling Paper > Output Stacker
→P.614
Wheeled Output Stacker
>
7
619