LG DLEX3370 series Owner's Manual page 49

'1ROUBLESHOOTING
49
Before Calling For Service (conf.)
Problem Possible Causes Solutions
Steam does not • Water level error. • Unplug dryer and call for service.
generate but
no error code is
shown
Garments still , Too many or too different types • Small loads of 1 to 5 items work best.
wrinkled after of garments in dryer. • Load fewer garments. Load similar-type garments.
STEAM FRESH
TM
There are no , The function of this cycle is to • Use an iron to make creases.
creases left on remove wrinkles from fabric.
garment after
STEAM FRESWM
Garments have , This is normal. • Depends on individual moisture level in skin.
static after
REDUCE STATIC
Garments are , Correct drying options not • Select load weight manually before starting REDUCE
too damp or selected. STATIC option.
too dry after
REDUCE STATIC
Garments are , Number of garments or load • Select the correct number or garments or load size before
not uniformly size not properly selected at the starting the cycle.
clamp after beginning of the cycle.
EASY IRON
Water drips , This is normal. • Condensation will normally form on the inside of the
from door dryer door during steam operation. Some condensation
during Steam may drip out the bottom of the door.
Cycle
Steam is not , This is normal. • Steam vapor is difficult to see when the door is closed.
visible during However, condensation will normally form on the inside of
Steam Cycle the dryer door if the steam system is operating normally.
Drum does not , This is normal. • The drum is turned off so that the steam vapor remains in
turn during the drum. The drum will normally turn for about 2 seconds
Steam Cycle once a minute.
Cannot see , This is normal. • Steam is released at different stages of the cycle for each
steam vapor at option.
the beginning
of cycle