Table of Contents
Advertisement
Available languages
Available languages
IMPORTANT SAFETY INSTRUCTIONS
When using your flat iron, basic safety precautions should always be followed, including
the following:
READ ALL INSTRUCTIONS BEFORE USING
1.
Use iron only for its intended use.
2.
To protect against a risk of electric shock, do not immerse the iron in water or other
liquids.
3.
The iron should always be turned to ' Off ' before plugging or unplugging from
outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to
disconnect.
4.
Do not allow cord to touch hot surfaces. Let iron cool completely before putting
away. Loop cord loosely around iron when storing.
5.
Always disconnect iron from electrical outlet when filling with water or emptying and
when not in use.
6.
Do not operate iron with a damaged cord or if the iron has been dropped or dam-
aged. To avoid the risk of electric shock, do not disassemble the iron take it to a
qualified serviceman for examination and repair. Incorrect reassembly can cause a
risk of electric shock when the iron is used.
7.
Close supervision is necessary for any appliance being used by or near children. Do
not leave iron unattended while connected or on an ironing board.
8.
Burns can occur from touching hot metal parts, hot water, or steam. Use caution
when you turn a steam iron upside down – there may be hot water in the reservoir.
9.
If the malfunction indicator goes on, the flatiron is not operating normally. Disconnect
from the power supply and have the flatiron serviced by qualified service personnel.
10. The iron must be used and rested on a stable surface.
11. When placing the iron on its stand, ensure that the surface on which the stand is
placed is stable.
12. The iron is not to be used if it has been dropped, if there are visible signs of damage
or if it is leaking.
13. This appliance is not intended for use by persons (including children) with reduced
physical,sensory or mental capabilities,or lack of experience and knowledge,unless
they have been given supervision or instruction concerning use of the appliance by
a perliance by a person responsible for their safety.
14. Children should be supervised to ensure that they do not play with the appliance.
15. If the supply cord is damaged,it must be replaced by the manufacturer,its service
agent or similarly qualified persons in order to avoid a hazard.
SPECIAL INSTRUCTIONS
1.
To avoid a circuit overload, do not operate another high wattage appliance on the
same circuit.
2.
If an extension cord is absolutely necessary, a 10-ampere cord should be used.
Cords rated for less amperage may overheat. Care should be taken to arrange the
cord so that it cannot be pulled or tripped over.
SAVE THESE INSTRUCTIONS
More specifically:
DO NOT
NEVER
DO NOT
DO NOT
NEVER
DO NOT
DO NOT
DO NOT
DO NOT
PLEASE NOTE!
Do not use chemical additive, scented substances or decalcifiers. Failure to com-
ply with the above-mentioned regulations leads to the loss of guarantee.
2
6_Instruction Manual.indd 2
let children or untrained persons use the appliance without supervision.
immerse the iron, cable or plug in any liquid.
leave the hot iron touching fabrics or very inflammable surfaces.
leave the appliance unnecessarily plugged in. Disconnect the plug from the
mains when the appliance is not being used.
touch the appliance with wet or damp hands.
use the power cord or the appliance in order to pull the plug out of the
socket.
leave the appliance exposed to the weather (rain, sun, etc.).
leave the iron without supervision when it is connected to the power supply.
fill the reservoir with water before removing the plug from the socket.
08.02.2012 09:02
Advertisement
Table of Contents
