How To Connect The Pc Input Terminals - Panasonic TH-37PA30 Operating Instructions Manual

Connections

How to connect the PC Input terminals

COMPUTER
Conversion adapter
(if necessary)
Notes:
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200
lines.)
• The display resolution is a maximum of 640 × 480 dots (TH-37PA30), 768 × 768 dots (TH-42PV30), 1,024 × 768 dots
(TH-50PV30) when the aspect mode is set to "4:3", and 852 × 480 dots (TH-37PA30), 1,024 × 768 dots (TH-
42PV30), 1,366 × 768 dots (TH-50PV30) when the aspect mode is set to "16:9". If the display resolution exceeds
these maximums, it may not be possible to show fine detail with sufficient clarity.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
Signal Names for D-sub 15P Connector
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
Pin Layout for PC Input
Terminal
Ofrecido por www.electromanuales.com
SD CARD
PUSH-EJECT
STR F / / TV/AV
Ferrite core (Small size)
(supplied)
AUDIO
Connect a cable which matches the
audio output terminal on the computer.
Less than
10 cm
Pin No. Signal Name
1 R
2 G
3 B
4 NC
5 GND (Ground)
PC CARD EJECT
S VIDEO VIDEO L R PC
AV3
Less than
10 cm
Stereo plug
RGB
PC cable
Ferrite core (Large size)
(supplied)
Pin No. Signal Name
6 GND (Ground)
7 GND (Ground)
8 GND (Ground)
9 NC (not connected)
10 GND (Ground)
S VIDEO VIDEO L R PC
AV3
Less than
10 cm
D-sub 15p
Pin No. Signal Name
11 NC (not connected)
12 NC
13 HD/SYNC
14 VD
15 NC
11