Universal Remote System; Operation - Cadillac SRX 2011 Owner's Manual

Gate Operator and Canadian
Programming
If you have questions or need help
programming the Universal Remote
system, call 1 800 355 3515 or go
to www.homelink.com.
Canadian radio-frequency laws
require transmitter signals to time
out or quit after several seconds of
transmission. This may not be long
enough for the Universal Remote
system to pick up the signal during
programming. Similarly, some U.S.
gate operators are manufactured to
time out in the same manner.
If you live in Canada, or you are
having difficulty programming
a gate operator or garage door
opener by using the Programming
the Universal Remote System
procedures, regardless of where
you live, replace Step 2 under
Programming the Universal
Remote System with the following:
Continue to press and hold
the Universal Remote system
button while you press and
release every two seconds (cycle)
the hand-held transmitter button
until the frequency signal has
been successfully accepted by
the Universal Remote system.
The Universal Remote system
indicator light will flash slowly at
first and then rapidly. Proceed with
Step 3 under Programming the
Universal Remote System to
complete.
I n f o r ma t i o n P r o v i d e d b y :
Instruments and Controls

Universal Remote System

Operation

Using the Universal Remote
System
Press and hold the appropriate
Universal Remote system button
for at least half of a second.
The indicator light will come on
while the signal is being transmitted.
Erasing Universal Remote
System Buttons
All programmed buttons should be
erased when the vehicle is sold or
the lease ends.
To erase all programmed buttons
on the Universal Remote system
device:
1. Press and hold down the
two outside buttons until the
indicator light begins to flash.
This should take about
10 seconds.
2. Release both buttons.
5-51