Lowrance MapCreate 6 Installation And Operation Instructions Manual page 9

clude in your map. Use the
east or west. Use the
needed to close in on or back away from the area you're viewing.
3. Click the
D
pointer above and to the left of the desired area. Click, hold down the
mouse button and drag diagonally down and to the right until the de-
sired area is enclosed with the green border box. Then release the
mouse button. You have just drawn a Map Border.
4. With the Map Border displayed, click the
ton, on the Create Map toolbar. After a moment it will tell you your map's
file size. If it fits the card, click
If the map file is too large for the card, click
redraw your map border a little smaller. Click the
ton, click on any green border line, then re-draw a smaller border box. Use
the Estimate button to re-check the size until it is correct.
Click the OK button to clear the message box from your screen.
5. When your file is the right size, click the
Create Map toolbar. The program displays a message about copyright
and encryption.
6. If this is the first time you have tried to save a file to your memory
card, MapCreate will need to register the card. Make sure you have a
card in your card reader. Click
the process.) If you have already registered the card you are using, click
and skip to step 11.
O
K
Read the message, and then click OK to continue.
Z
OOM
M B
RAW AP ORDERS
buttons to move north, south,
P A
AN RROW
and
-I Z -O
N OOM
button in the toolbar. Move the mouse
to clear the message and jump to step 5.
O
K
to continue. (Clicking Cancel ends
O
K
3
( or
Z-I Z-O
UT N
E C
STIMATE USTOM
to clear the message, then
O
K
D M
ELETE
C M
REATE AP
) buttons as
UT
but-
M S
AP IZE
but-
B
AP ORDER
button on the