SECTION 3: HARDWARE PACK
Please identify each piece of the hardware pack as
shown in Figure 1.
Wing Nut 1/4-20 (2)
SECTION 4: UNPACKING
Removing Unit From Carton
•
Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton.
•
Remove loose parts included with unit (i.e.,
operator's manual, oil, etc.).
•
Cut corners and lay carton down flat. Remove
packing material.
SECTION 5: ASSEMBLING YOUR LAWN MOWER
Tools Required
•
Pair of Pliers
•
Funnel
•
Set of adjustable wrenches
Disconnecting Spark Plug
•
Before setting up your lawn mower, disconnect the
spark plug wire from the spark plug, and ground it
against the engine. See Figure 2.
•
Attach the spark plug wire to a bolt on the engine to
ground it.
Spark Plug
Wire
Figure 2
Carriage Bolt 1/4-20 (2)
Spark Plug
•
Roll or slide unit out of carton. Check carton
thoroughly for loose parts.
NOTE: Make sure not to crimp the cables while
removing the loose parts or the entire unit from the
carton.
NOTE: Reference to right or left hand side of the mower
and/or front or behind the mower is observed from the
operating position.
Assembling Handle
•
Remove grass bag from the unit and set it out of the
way. See Figure 3 (step 1).
•
Remove any packing material which may be
between the upper and lower handles for shipping
purposes.
2. Lift lower handle
3. Lift upper
handle
•
Raise the lower handle in the direction shown in
Figure 3 (step 2) till it snaps into place.
7
Figure 1
1. Move bag
away
Figure 3