COZY VFM103 Installation And Operation Instructions Manual page 12

VFM203 - NATURAL GAS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A
FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PER-
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instruc-
tions exactly.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electric switch, do not use any
phone in your building.
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
1. STOP! Read the safety information above on this
label.
2. Depress gas control knob slightly and turn clockwise
to "OFF".
3. Turn off all electric power to the appliance.
NOTE: Knob can not be turned from "PILOT" to "OFF" unless
knob is depressed slightly. Do not force.
4. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP! Follow "B" in the safety information above
on this label. If you don't smell gas, go to the next
step.
5. Locate pilot in the cut-out below the burner.
6. Locate piezo ignitor button on top of heater.
1. Depress gas control knob slightly and turn clockwise
2. Turn off all electric power to the appliance if service is to be performed.
SONAL INJURY OR LOSS OF LIFE.
LIGHTING INSTRUCTIONS
Gas
Control
Knob
TO TURN OFF GAS TO APPLIANCE
VFM204 - L.P. GAS
If you cannot reach your gas supplier, call the
fire department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or turn by hand, don't try to repair it, call a
qualified service technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
7. Turn gas control knob counterclockwise
"PILOT".
8. Depress gas control knob and hold in. Immediately
begin alternately pushing and releasing piezo
ignitor button, observing pilot, until pilot is lit.
Continue to hold the control knob in for about
one (1) minute after the pilot is lit. Release the
gas control knob and it will pop back up. Pilot
should remain lit. If pilot goes out, repeat steps
2 thru 7.
If knob does not pop up when released, STOP and
immediately call your service technician or gas
supplier.
If the pilot will not stay lit after several tries, turn
the gas control knob to "OFF" and call your
service technician or gas supplier.
9. Turn on all electric power to the appliance.
10. Turn gas control knob counterclockwise
desired "LO" or "HI" setting.
to "OFF".
Page 12
to
to