Cd5Si Introduction And Installation; Cd5Si In Use - NAIM CD555 Owner's Manual

C D5si
1 3 C D5si In tro duc t ion an d I nst allat i on
The CD5si should be installed on a dedicated equipment stand intended for the purpose. Do
not stand the player directly on top of another item of Naim Audio equipment. Care should be
taken to ensure that the player is level.
A transit screw on the underside of the CD5si case should be removed before use and must be
replaced if the unit is to be re-packed and shipped. This transit screw must not be used in any
other Naim product. Do not invert the player once the transit screw is removed.
CD player control and operation is described in Sections 16, 17 and 18.
1 4 C D5si Co nne ct io ns
14 .1 Rea r Pa nel
Power
Mains
switch
input and
fuse
1 5 C D 5si In Use
1 5.1 Disc L o ad ing
To load a compact disc pull open the CD drawer using the
handle on the left hand side of the player. Place the disc on
the platter followed by the magnetic puck. Do not use a puck
from any other Naim CD player. Different Naim CD players use
dissimilar pucks.
E10
Note: RCA phono and DIN output sockets should not be
connected simultaneously.
DIN output
Phono
Phono
output
output
left right
1 5. 2 Playe r Ma i n te n a n ce
It is important for reliable operation of the CD5si to ensure that
the surfaces of the transport platter and the underside of the
puck are free of dust or debris which can prevent the disc from
sitting properly and cause it to slip.
To clean the transport platter, take a piece of Blu-Tack and
lightly apply it to the top surface of the magnetic metal hub,
picking up any material attached to it. Brush the plastic outer
edge lightly with your finger or a soft brush to ensure that it is
dust and particle free. Similarly, clean the puck with Blu-Tack,
to remove debris from its underside.
Do not, under any circumstances, use any solvents or fluids for
the cleaning process.
CD5si
DIN Output
ch1 nc
ch2 nc
-ve