Vertex Standard VXA-210 Service Manual page 5

The VXA-210's Book Memories also allow the user to
store, label, and recall channel frequencies which you may
want to use frequently while the VXA-210 is in the Field
Programming mode.
Memory Storage into the Book Memory
r Press and hold the PTT and LAMP switches while
turning the radio on, to activate the Field Program-
ming Mode.
r Select the desired frequency to be stored in the Book
Memory.
r Press and hold the [ MW ( SPL.W )] key for 2 seconds.
The display will indicate "BOOK - " and a channel num-
ber will blink on the LCD.
r Within five seconds of pressing the [ MW ( SPL.W )]
key, rotate the DIAL selector knob to select the de-
sired memory channel number for storage.
r Now press and hold in the [ MW ( SPL.W )] key for 2
seconds; you will now see " - - - - - - - - " on the LCD.
Supplied Accessories
Ni-Cd Battery Pack (7.2V, 700mAh) FNB-64
Overnight Desktop Charger
Helical Antenna
Headset Cable
Operating Manual
Warranty Card
ø : "B" suffix is for use with 120 VAC,
"C" suffix is for use with 230-240 VAC, or
"U" suffix is for use with 230 VAC.
Available Options
MH-44 Speaker Microphone
A4B
FNB-V57 Ni-Cd Battery Pack
(7.2V, 1100mAh)
FBA-25 Alkaline Battery Case
VAC-800 Desktop Rapid Charger
E-DC-5B External Power Cable
SU-1 Barometric Pressure Sensor Unit
CN-3 Antenna Adapter (SMA to BNC)
Availability of accessories may vary. Some accessories are supplied as standard per local requirements, while others may
be unavailable in some regions. Consult your Vertex Standard Dealer for details regarding these and any newly-available
options.
Connection of any non-Vertex Standard-approved accessory, should it cause damage, may void the Limited Warranty on
this apparatus.
Operating Manual Reprint
F P
IELD ROGRAMMING
A
CCESSORIES
ø
NC-77B/C/U
ATV-7
CT-60
M
ODE
To attach an alpha/numeric name (label) to the
memory, proceed to the next step; otherwise press and
hold the [ MW ( SPL.W )] key for 2 seconds to save the
entry and exit.
r To label a memory with an alpha/numeric name, the
next step is to use the DIAL selector knob to select
any of the 48 available characters (including letters,
numbers, and special symbols). When the desired first
character appears, press down on the DIAL selector
knob momentarily to move on to the next character.
r Select succeeding characters in the same manner,
pressing down on the DIAL selector knob momentarily
after each selection.
r After entering the entire name (eight characters maxi-
mum), press the [ MW ( SPL.W )] key for 2 seconds to
save all data for the channel.
r Turn the radio off, then turn the radio back on again
to begin normal operation.
& O
PTIONS
á External Antenna
CN-3 Antenna Adapter (Option)
CT-60 Headset Cable
1 2 3
4 5 6
7 8 9
MW 0 F
E-DC-5B External Power Cable
(Partial)
Headset
(not supplied)
PTT Switch
(not supplied)
5