First Installation; Batteries - Remote Control; Connecting; Switching On - Loewe Mimo 15 SAT Operating Instructions Manual

First installation

Batteries – Remote
Control
To insert or replace the batteries, press where
an arrow is imprinted. Slide the battery
compartment cover downwards and remove it.
Insert Alkaline Manganese LR 03 (AAA)
batteries and make sure + and – poles are
located in the correct positions.
Then slide on the cover again.
Notes on battery disposal:
The original batteries do not
contain any pollutants such as
cadmium, lead and mercury.
Used batteries do not belong in
the domestic waste. They must
be taken to the appropriate
collection points according to
the national laws. Ask your
dealer.
Set remote control to TV set operation
Press TV button
TV
Page 26/27 describes how you operate other
Loewe units.
LCD_SAT_31715022_GB

Connecting

Remove the cable cover at the back of the unit
by pressing down simultaneously both plastic
locking tabs (see arrows in figure), and then
pulling off the cover.
Move the cables downwards and outwards.
Open the cable holder in the lower area and lay
the cables in the cable holder. When all cables
are positioned correctly, close the cable holder.
Refit the cover by inserting it into the two
lower slots and clipping it shut at the top.
+
+
Mains
Connect the AC adapter to a 230 Volt/50–60
Hertz outlet.
Plug the low voltage cable of the AC adapter to
the "AC adapter" socket on the TV set.
9
Satellite antenna
Connect the cable of the satellite antenna to
the antenna socket (F socket) of the television
set. Ensure that the pin in the centre of the F
plug is not bent and is not in contact with the
external metal ring.

Switching on

The indicator and the on/off switch are
combined in one unit.
Press the on/off button. The green ON indicator
lights.
When you switch on for the first time the
automatic programming of the TV is prepared.
If the equipment has already been in operation,
you can repeat the first commissioning, e.g.
after moving house. To do this, call the
"Main information" with the INFO button.
Then select "First installation" in the "Index".
Then start "First installation" with OK.
10.08.2004, 15:44 Uhr
9