Turning Off The Power - Sony VPL-CX236 Operating Instructions Manual

3 The cursor will disappear if the
adjustment range limit is reached.
Press the RESET key to restore the projected image before adjustment.
Automatically adjusts Phase, Pitch and Shift of projected image while a
signal is input from a computer (APA (Auto Pixel Alignment))
Press APA on the remote commander. Press again to cancel during the setting.
If Smart APA is set to On, executes APA automatically when a signal is input (page 24).

Turning Off the Power

1
Press the ?/1 key on the main unit or the Remote Commander.
The shutdown message appears.
If you do not press any of the keys for a while, the projector will turn off.
If you press ?/1 on the projector or remote commander while the shutdown message is on
the screen, the projector will restart.
Note
Do not turn off the projector soon after the lamp lights. It may cause a malfunction of the lamp
(does not light ,etc.).
2
Unplug the AC power cord from the wall outlet.
After step 1, the fan continues to run for a while to reduce internal heat, however, you may
also unplug the AC power cord before the fan stops.
To turn off without displaying confirmation message
?/1
Hold the key on the main unit pressed for a few seconds.
ECO gauge
This gauge indicates the current effectiveness of the projector's ECO function. (For details on
the ECO function, see "ECO MODE key" (page 6), "AUTO POWER SAVING" (page 24) and
"Lamp Mode" (page 27)). The leaf icons are displayed when the projector is shut down. The
number of displayed icons varies according to how much energy is saved as a result of using
the ECO function.
18
Projecting an Image
ECO gauge
Example of cursor display:
You can adjust in all directions.
You can adjust only to the left/
right or downwards.