Maintenance Schedule - Lochinvar EnergyRite ER152 User's Information Manual

1

Maintenance schedule

Service technician
(see the EnergyRite Service Manual for
instructions)
General:
• Address reported problems
• Inspect interior; clean and vacuum if
necessary
• Check for leaks (water, gas, and flue)
• Verify flue and air lines in good
condition and sealed tight
• Check control settings per the Access
Setup Menu in the EnergyRite Service
Manual
• Check ignition and flame sense
electrodes (sand off any deposits;
clean and reposition)
• Check wiring and connections
• Perform
performance verification per Section 9
in the EnergyRite Installation and
Operation Manual.
• Flame inspection (stable, uniform)
If combustion or performance
indicate need:
• Clean burners
• Clean heat exchanger
Follow the maintenance procedures given throughout this manual. Failure to perform the service and
WARNING
maintenance or follow the directions in this manual could result in damage to the pool heater or system,
resulting in severe personal injury, death, or substantial property damage.
start-up checkout and
Owner maintenance
(see the following pages for instructions)
Daily
• Check pool heater area
• Check vent piping
• Check
Monthly
applicable)
• Check relief valve (if applicable)
• Test low water cutoff (if used)
Periodically
• Reset button (low water cutoff)
• Check pool heater piping (gas
Every and water) for leaks
6 months
• Operate
applicable)
• Shut the pool heater down and
winterize if location is subjected
to freezing temperatures, see the
End
Winterizing
of season
EnergyRite Service Manual
User's Information Manual
air inlet piping
relief valve
section in
5
(if
(if
the