Optional Room Air - Lochinvar ARMOR 151 Installation And Operation Manual

3
General venting
Vent, air piping and termination:
The Armor water heater vent and air piping can be
installed through the roof or through a sidewall. Follow the
procedures in this manual for the method chosen. Refer to
the information in this manual to determine acceptable vent
and air piping length.

Optional room air

Optional room air is intended for
NOTICE
commercial applications.
air piping to the outside is recommended
for residential applications.
Commercial applications utilizing the Armor water heater
may be installed with a single pipe carrying the flue products
to the outside while using combustion air from the equipment
room. In order to use the room air venting option the
following conditions and considerations must be followed.
• The unit MUST be installed with the appropriate
room air kit (Table 3F).
• The equipment room MUST be provided with
properly sized openings to assure adequate
combustion air. Refer to the instructions provided
with the room air kit.
• There will be a noticeable increase in the noise level
during normal operation from the inlet air opening.
• Using the room air kit makes the unit vulnerable to
combustion air contamination from within the
building. Please review Section 1, Prevent
Combustion Air Contamination, to ensure proper
installation.
• Vent system and terminations must comply with the
standard venting instructions set forth in this
manual.
WARNING When utilizing the single pipe method,
provisions for combustion and ventilation
air must be in accordance with Air for
Combustion and Ventilation, of the
latest edition of the National Fuel Gas
Code, ANSI Z223.1, in Canada, the latest
edition of CGA Standard B149 Installation
Code for Gas Burning Appliances and
Equipment, or applicable provisions of the
local building codes.
(continued)
Table 3F Optional Room Air Kit
Model
151 - 200
286 - 801
400 - 801
Air contamination
Pool and laundry products and common household and hobby
Combustion
products often contain fluorine or chlorine compounds. When
these chemicals pass through the water heater, they can form
strong acids. The acid can eat through the water heater wall,
causing serious damage and presenting a possible threat of flue
gas spillage or appliance water leakage into the building.
Please read the information given in Table 1A, page 11, listing
contaminants and areas likely to contain them. If contaminating
chemicals will be present near the location of the water heater
combustion air inlet, have your installer pipe the water heater
combustion air and vent to another location, per this manual.
WARNING
WARNING
Installation & Operation Manual
Kit Number Description
KIT30052 Room Air Kit
KIT30053 Room Air Kit
KIT30054 Room Air Filter Kit
If the water heater combustion air inlet is
located in a laundry room or pool facility,
for example, these areas will always contain
hazardous contaminants.
To prevent the potential of severe personal
injury or death, check for areas and products
listed in Table 1A, page 11 before installing
the water heater or air inlet piping.
If contaminants are found, you MUST:
• Remove contaminants permanently.
—OR—
• Relocate air inlet and vent terminations
to other areas.
23