Lochinvar ARMOR 150 - 800 Service Manual page 34

3
Troubleshooting
Model 500
Locate the throttle adjustment screw on top of the gas valve, see
FIG. 3-4. Using a screwdriver, turn the screw a 1/4 turn
counterclockwise to increase CO
to decrease CO levels. After one adjustment on the valve, follow
2
the Combustion Analysis Procedure on page 32 of this manual
to measure the combustion.
If combustion is still not within the specified range, repeat the
procedure. This procedure SHOULD NOT be performed more
than four (4) times. If after four (4) adjustments and the
combustion is still not within the specified range, revisit the
possible causes in Table 3F on page 32 or replace the gas valve.
Figure 3-4 Gas Valve Adjustment: Model 500
34
(continued)
levels or a 1/4 turn clockwise
2
Models 600 - 800
Locate the throttle adjustment screw on top of the gas valve,
see FIG. 3-4. Using an Allen wrench, turn the screw a 1/4 turn
counterclockwise to increase CO
clockwise to decrease CO
the valve, follow the Combustion Analysis Procedure on page
32 of this manual to measure the combustion.
If combustion is still not within the specified range, repeat the
procedure. This procedure SHOULD NOT be performed
more than four (4) times. If after four (4) adjustments and
the combustion is still not within the specified range, revisit
the possible causes in Table 3F on page 32 or replace the gas
valve.
Figure 3-5 Gas Valve Adjustment: Models 600 - 800
THROTTLE
ADJUSTMENT
SCREW
(REMOVE BLUE CAP)
Service Manual
levels or a 1/4 turn
2
levels. After one adjustment on
2