Insignia NS-LCD47HD-09 Service Manual page 8

47"LCD TV Best Buy NS-LCD47HD-09
USING YOUR TV
To turn your TV on and off:
1 Make sure that the power cord is connected to your TV and a power outlet.
2 Press the POWER button to turn on your TV. The power indicator LED turns blue.
3 Press the POWER button again to return your TV to standby. The power indicator LED turns red.
To select the TV signal source:
• With the TV on, press the INPUT button on either the TV or the remote to choose from:
• TV
• Composite Rear
• Composite Side
• S-Video Rear
• S-Video Side
• Component1
• Component2
• VGA
• HDMI1
• HDMI2
• HDMI3
Press VIDEO to choose between Composite and S-Video.
Setting up the channel list:
After you select your TV source, if you selected antenna or cable you need to set up the channel list. When you set
up your channel list, your TV searches for all available channels in your area and store a list of these channels.
When you press the CH ＾ or CH v buttons, your TV skips the channels that do not have a signal.
To automatically set up the channel list:
1 Press the MENU button. The Main on-screen display menu opens with Setup highlighted.
2 Press the > button to enter the sub-menu, then ▽or △button to highlight Auto Ch Search.
3 Press ENTER or > to start the search.
Manually adding or deleting channels from the channel list
After you create a channel list using the Auto Ch Search option, you can manually add or delete channels from the
channel list.
To add or delete channels:
1 Press the MENU button. The Main OSD (On-Screen Display) menu opens with Setup highlighted.
2 Press the > button to enter the sub-menu, then ▽or △ to highlight Manual Channel Set. The Channel Setup
Table opens.
3 Press the ▽or △ button to select a channel, then press then press ENTER to toggle between viewable and not
viewable.
4 Press MENU or EXIT to close the menu.
To change channels:
• Press the CH v or CH ^ button on the remote control to go to the next lower or higher channel. Or Press the
8