Offline Mode Setting - Sharp MX-CF10 Service Manual

[Exiting from reverse section]
Step 17: When the inserter reverse motor has completely stopped, the
inserter reverse motor starts to reverse, and the transport
motor starts.
Step 18: The inserter reverse sensor is turned ON, and detects the
leading edge of the sheet.
Step 19: The inserter paper exit sensor is turned ON, and detects the
leading edge of the sheet.
Step 20: The inserter reverse sensor is turned OFF. When the sheet
travels a predetermined distance after its trailing edge is
detected, the inserter reverse motor stops.
(If the next sheet waits at the leading-edge registration posi-
tion, the flapper solenoid in the reverse section is turned ON,
the inserter paper feed motor starts to rotate in the forward
direction, and the inserter reverse motor starts to rotate in the
forward direction.)
[Paper exit]
Step 21: The inserter paper exit sensor is turned OFF, and the trailing
edge of the sheet is detected.
Step 22: If there are no more sheets to be inserted, the transport
motor stops.

4. Offline mode setting

A. How to set punching mode
The figure below shows the operator panel.
Punch LED
Setting procedure:
Step 01: Place a sheet in the tray.
Step 02: Press the PUNCH switch on the operator panel.
Step 03: The PUNCH LED lights up to indicate that setting has been
Step 04: Press the START switch to start operation.
Canceling procedure:
Step 01: Press the PUNCH switch on the operator panel.
Step 02: The PUNCH LED goes out to indicate that setting has been
Note: If you cannot make or cancel setting by following the respective
B. How to set stapling mode
Setting procedure:
Step 01: Place a sheet in the tray.
Step 02: Press the STAPLE MODE switch on the operator panel.
Step 03: Each time you press the switch, the STAPLE MODE LEDs
Step 04: When the desired LED lights up, press the START switch to
(Refer to the correspondence between the stapling modes and LEDs
shown later.)
Canceling procedure:
Step 01: Press the STAPLE MODE switch on the operator panel.
Step 02: All the STAPLE MODE LEDs go out to indicate that setting
Note 1: If you cannot make or cancel setting by following the respec-
Note 2: The punching mode and saddle mode cannot be used at the
MX-CF10 OPERATIONAL DESCRIPTION 4 - 4
Punch switch
completed.
canceled.
procedures above, refer to section "5." shown later. When no
LEDs are lit, check the setting made by the main unit and the
inserter status.
Staple mode LED 2
Staple mode LED 1
Staple mode LED 3
Staple mode LED 4
light up by turns in the following order: 1 → 2 → 3 → 4 → All
LEDs OFF → 1 → ... (When the saddle mode cannot be
used, the order is: 1 → 2 → 3 → All LEDs OFF → 1 → ...)
start operation.
has been canceled.
tive procedures above, refer to section "5." shown later.
When no LEDs are lit, check the setting made by the main
unit and the inserter status.
same time.
Start LED
Start switch
Start switch
Start switch
Staple mode switch