Cleaning The Filters; Cleaning The Spray Arms - Viking 3 Series Use And Care Manual

Care and Maintenance

Cleaning the Filters

Clean the fi lters and the spray arms regularly. A dirty dishwasher will have
a negative eff ect on the cleaning results.
The following fi lters are to be cleaned:
1 Main fi lter
2 Coarse fi lter
3 Micro fi lter
• Remove the lower rack from the machine.
• Turn the coarse fi lter counterclockwise to the left and pull it out in an upward direction A.
• Pull out the main fi lter B.
• Press on the two tabs of the coarse fi lter and remove the micro fi lter C.
• Clean the fi lters thoroughly under running water. Use a brush if necessary.
• Replace main fi lter.
• Replace the micro fi lter and the coarse fi lter into the main fi lter.
• Twist it clockwise until it clicks into place.

Cleaning the Spray Arms

1 Lower spray arm
2 Upper spray arm
• Remove the lower rack from the machine.
• Pull off the lower spray arm in an upward direction A.
• Loosen the fastening screw of the upper spray arm and pull off the
spray arm B by a downward motion.
• Clean the spray arms under running water.
• Replace the lower spray arm in a downward direction.
• Replace the upper spray arm and tighten the fastening screw by
turning it around to the left.
• Insert the lower rack.
Check if the holes on the top of the third spray arm are clogged. If they are clogged, remove and
clean them.
To remove them, slightly push them upwards (1) and then turn clockwise (2).
To replace the impeller, seat it into its slot, push slightly upwards and turn it counter clockwise
until it is securely fi tted. When the impeller is released, check if it rotates without any
obstruction.
NOTICE
Dirt and/or calcium residue may block the nozzles on the spray
arms. For this reason, regularly check the spray nozzles.
Made sure the fastening screw is tight on the upper spray arm.
21
CAUTION
DO NOT operate your dishwasher without a fi lter.
You will damage your machine. Ensure that your
fi lters are correctly installed.
CAUTION