Panasonic Workio DP-190 Operating Instructions Manual page 21

2
5
The document(s) will be stored into memory with
a file number when sending from the ADF (Auto
Document Feeder).
Then starts dialing the telephone number or
connecting to the LAN immediately after storing
the first page. (See Note 5)
The remaining page(s) continue to store into
memory.
• If memory overflow occurs while storing documents, the remaining documents on the ADF
will be ejected. In the factory default setting (Fax Parameter No. 82 (Quick Memory XMT)
is set to "Valid"), the machine will transmit the stored documents automatically when
transmitting to one station. If Fax Parameter No. 82 is set to "Invalid" and transmitting to
one station, the machine will change the transmission mode from Memory to Direct XMT
automatically when it detects that memory overflow will occur.
In the "Valid" setting, the machine will show "MEMORY FULL" and prompts you whether
to transmit the successfully stored documents or to cancel the transmission.
Press
seconds, the machine will start transmitting the stored documents.
If memory overflows while storing 1st page, use Direct Transmission.
• An Information Code will be displayed if the transmission has failed or there was no
answer at the receiving side after the last automatic redial.
The document stored for the transmission will be erased from the memory automatically
and the information code is printed for the transmission on the Communication Journal
(COMM. JOURNAL).
If you need to retain the incomplete documents even after the last redial, change the Fax
Parameter No. 31 (INC. FILE SAVE) to "Valid" in advance. (See page 141)
To retry the incomplete documents, refer to page 104.
5. If you are using Pulse dialing and you wish to change to Tone dialing in the middle of dialing,
NOTE
press
The dialing mode will be changed from Pulse to Tone after dialing the digit "/".
Ex: 9 PAUSE TONE 5551234
6. This feature is called "Quick Memory Transmission". If you wish to store All the document(s)
into memory first before transmitting, change the Fax Parameter No. 82 (QUICK MEMORY
XMT) to "Invalid".
7. The "QUICK MEMORY TRANSMISSION" feature is disabled if multiple stations are set.
Selecting the desired
3
Transmission setting.
(See page 11)
"YES" to cancel or press
1
(represented by a "/").
TONE
4a
4b
4c
4d
6
When an original is scanned from the Platen
Glass, the message "ANOTHER
ORIGINAL?" is shown.
Place another original, then
press
START
Machine starts sending.
"NO" to transmit. If no action is taken within 10
2
.
21