Sharp LC-70LE740E Service Manual page 68

LC-60/70LE740E/RU,741E/S,743E,60LE840E/RU,841E/S,843E,80LE645E/RU,646E/S,648E (1st Edition)
5. Operation after "RESET"
Select "RESET" in the PUBLIC Mode, and it operates as follows when it is executed (refer to the basic operation).
• The set contents in the PUBLIC mode are initialized.
• It does not exit the PUBLIC mode.
• If "EXCUTE" is not executed, the content that does RESET is not reflected.
6. Setting items. (* Item names and selective items are expressed in English.)
1) Power ON fixed [POWER ON FIXED]
Option "VARIABLE", "FIXED_ALL", "FIXED_BODYKEY" or "RCRESPOND" (loop enabled)
Default "VARIABLE"
Function • VARIABLE
• FIXED_ALL
• FIXED_BODYKEY
• RC RESPOND
Key disabled when set • OFF TIMER (SLEEP) (*Only when setting to FIXED_ALL)
other than default
Remarks • When selecting to "FIXED_ALL", function related standby factors (see below) doesn't work. and not selecting.
* These items does not exist according to the model.
If the power button is pressed in the ordinary mode in setting to "FIXED_ALL" and "FIXED_BODYKEY", the caution is displayed for 5 seconds.
When power button on the main unit is pressed
No Power off by power button.
* The OSD display is an example.
If another ODS is previously displayed, the status is reset (MENU or similar).
2) Instantaneous current shutdown setting in turning off the power [SHUT DOWN MODE]
Option "NORMAL" or "QUICK"
Default NORMAL
Function • This function decides whether scanning digital tuner is enabled or disabled when the power is standby.
NORMAL
QUICK
Remarks In selecting "QUICK", the function does not work for the following items. (selection impossible.)
• ON TIMER, QUICK START, DIGITAL FIXED, etc.
* These items does not exist according to the model.
3) Volume maximum level [MAXIMUM VOLUME]
Option 0~60 (loop disabled)
Default 60
Function The volume cannot be increased more than the adjusted value (the main unit's speaker only).
Remarks • When setting to 59 or less, only the figure is displayed in the normal mode; the volume bar is not displayed.
• The volume of the headphones is limited.
• The setting is impossible when VOLUME FIXED is set to FIXED.
: "POWER/RECEPTION" key on TV unit or remote control is enabled.
: "POWER/RECEPTION" key on TV unit or remote control is disabled.
: Only the "MAIN POWER" key on TV unit is disabled (The remote control is enabled).
: The main unit's POWER switch toggles between ON and Standby (the same operation by the
remote control).
OFF TIMER (Sleep)
No operation OFF
No signal OFF (including the power management)
: Scanning digital tuner is enabled when the power is standby.
: Scanning digital tuner is disable.
It is possible to put into the standby state instantaneously due to power off input, when the
power is standby.
Immediately, state is a complete standby.
When power button on R/C is pressed
No Power off by remote control.
5 – 31