Remote Control Description; Battery Installation And Removal; Remote Control Functions - Krell Industries KAV–280cd Owner Reference Manual

Remote Control Description

See Figure 3 on page 11
Battery
Installation
and
Removal
Notes
Remote Control
Functions
POWER
COMPACT
DISC
TRANSPORT
FUNCTIONS
Note
12
The KAV–280cd remote control uses one CR2025 lithium battery, which
is included with the shipment.
To open the battery compartment on the back of the remote control:
1. Place the remote face down on the table.
2. Use your thumbnail or a small jeweler's or eyeglass screwdriver to
move the small tab toward the center of the remote, while using your
index fingernail or screwdriver to pull down gently on the slot to the
right of the tab. The battery compartment will slide out.
3. Place the battery, plus side up, in the battery tray.
4. Slide battery compartment back into the remote until you hear a click.
The remote control is ready for operation.
Do not use a knife or other sharp objects to open the battery compartment; they
will scratch the remote control finish.
Replace batteries when remote control function becomes intermittent.
Remove batteries if the remote control is not used for a long period of time.
Battery leakage can damage the remote control.
The KAV–280cd remote control provides power, compact disc transport,
and compact disc programming functions. A description of the remote
control keys that are used with the KAV–280cd follows.
22 Power Key
Use this key to switch between stand-by and operational modes.
23 CD Key
Use this key to activate the compact disc and power functions on the
KAV–280cd remote control.
24 Dis (Display) Key
Use this key to cycle the front panel display between the elapsed time on
the current track, the elapsed time on the entire compact disc, and the
remaining time on the entire compact disc. See also How to Program a
Track Sequence, on page 16.
25 Direct Track Access Keypad
Use the direct track access keypad to select a compact disc track. If
tracks consist of two digits, the numbers must be pressed within eight
seconds of each other. See also How to Program a Track Sequence,
on page 16.
The +10 key is not functional on the KAV–280cd.
Krell KAV–280cd