Before Operation - Mitsubishi MBP15G Operator's Manual

Check Engine Oil
WARNING
DO NOT attempt to start this engine without filling the crank case
with the proper amount and type of oil. Your water pump has
been shipped from the factory without oil in the crankcase.
Operating the unit without oil can damage the engine.
Use class SE oil or a higher grade according to the table below. SAE
10W-30 or 10W-40 is recommended for general, all temperature
use.
10W
Single
20W
Grade
Oil
Multiple 10W-40
Grade
10W-30
Oil
– 30 – 20
Temperature° C
– 22 –4
° F
- Inspect the oil level by using the oil gauge
before starting the engine each time;
- Top off the oil level to the maximum level
mark and/or until oil flows from the
opening;
- Ensure both Oil Gauges are secure.
NOTICE
Low oil sensor
The unit is equipped with a low oil sensor. If the oil level becomes
lower than required, the sensor will activate a warning device or
stop the engine.
If water pump shuts off and the oil level is within specifications,
check to see if water pump is sitting at an angle that forces oil to
shift. Place on an even surface to correct this.
If engine fails to start, the oil level may not be sufficient to
deactivate low oil level switch. Make sure the sump is completely
full of oil.
Check Engine Fuel
WARNING
DO NOT refuel while smoking or near open flame or other such
potential fire hazards. Otherwise a fire accident may occur.
- Do not refill tank while engine is running or hot.
- Close fuel cock before refueling with fuel.
- Be careful not to admit dust, dirt, water or other foreign objects
into fuel.
- Wipe off spilt fuel thoroughly before starting engine.
- Keep open flames away.

BEFORE OPERATION

20#
30#
40#
5W-20
– 10 0 10 20 30
14 32 50 68 86
OIL GAUGE
Not Tightened
（
Lowest Oil Level
Fill the tank with clean, fresh unleaded
automotive gasoline
- Check fuel level.
- If fuel level is low, refill with unleaded
automotive gasoline.
- Be sure to use the fuel filter screen on the
fuel filter neck.
Check Air Cleaner to Make Sure It Is Clean
If not, please refer to "HOW-TO" MAINTENANCE.
Check Loose and Missing Parts
Before starting the water pump, check for loose or missing parts and
for any damage which may have occurred during shipment.
40
104
）
Regular Oil
Level
- 5 -
Fuel Level