After Printing; Removing The Label Backing - Brother P-touch 9500PC Quick Reference

After printing

This section contains the procedures to remove the label backing from the printed label to remove.

Removing the label backing

When the backing of a printed label is not cut,
use the included label stick. For labels printed
using the Half Cut option, peel back the
backing from the cut line.
1 Press the cover release button and open
the tape compartment cover.
Remove the label stick installed inside
2
the PT-9500PC tape compartment cover.
82
Hold one end of the printed label with
3
one hand and hold the label stick with
the other hand.
Insert half of the printed label into the
4
hole in the label stick with the printed
side facing up.
Turn the label stick and quickly pull as
5
shown in the illustration below.
→ The end of the label will come off of
the backing slightly.
6 Completely remove the backing from the
label and affix the label.