Electrical Supply Connection; Water Supply Connection - Rangemaster SxS 15 User Manual

Fig.4.13
ArtNo.601-0010 - SxS 661-9 - Pipe to filter
Fig.4.14
ArtNo.601-0005 - SxS 661-9 - Securing the pipe
Fig.4.15
ArtNo.601-0014 - Pipe to BSP connector
Fig.4.16

Electrical Supply Connection

Connect the appliance to the electrical supply (220-240 V ~
50 Hz) with the plug and lead, which are fitted.
Connections to the mains supply should be in accordance
with local regulations.
The appliance must be plugged into an earthed
n n
socket.
Always make sure that the plug is accessible after
n n
the appliance has been positioned.

Water Supply Connection

It is recommended to have this product installed by
n n
a qualified technician.
Note: For further installation details refer to the instructions
supplied with the water filter.
• Pressure of the cold water supplied to the automatic
icemaker is between 1.5-8.5 bar.
• The water tube should be of an appropriate length,
usually 8 metres, and should be free of bends after
being inserted into place. If the water pipe is too long
then the water pressure will be reduced, affecting the
ice and cold water content.
• DO NOT connect water supply when the ambient
temperature is below 0 °C, otherwise the water pipe
may freeze.
• Always use potable/drinking water.
• Keep the water tube clear of heat sources.
• The water filter is there to filter impurities in the water,
and to make ice clean and hygienic. It cannot sterilise
or destroy anything, so be certain to connect the water
pipe to a drinkable water source.
Fitting the Water Filter
Measure out and cut the length of pipe required from the
filter to the Fridge-freezer, and from the filter to the water
supply. Make sure that you achieve a square cut using a sharp
knife.
Push fit one of the pipes into the water filter (Fig.4.13).
Secure the pipe to the filter by sliding a locking clip into the
groove as shown (Fig.4.14).
Repeat the procedure on the other end of the filter.
Connect the end into the plastic adaptor (Fig.4.15). Screw
the adaptor onto a suitable ¾" connector water outlet.
Access the water valve assembly at the back of the appliance.
Push the pipe into the valve assembly (Fig.4.16).
Open the water valve to flush the pipe, check leakage in the
water pipe joints and allow the water to run until it is clear.
Comissioning the Water Dispenser
Before first use, press the water dispenser pad several times
for 1 minute. Do not press for more than 1 minute to prevent
overheating of the pad activator solenoid. Cold water will
begin to flow from the outlet.
17