Contents Before You Start About Your Refrigerator Food Storage Tips Installation Cleaning and Maintenance Troubleshooting Warranty/After Sales Service Technical Data...
1. Before You Start Thank you for buying a Rangemaster appliance. We hope are a safety hazard. Make sure that all connections are that it provides a stylish yet practical solution to your cooling sound. needs. We hope that this handbook supplies you with all the •...
2. About Your Refrigerator Fig.2-1 ������������� ����������������� ����������� ����������������� ������������������������� ���������������� ���������������� ������������������������� �������� ����������������� ����������� �������������������� ArtNo.600-0004 - Refrigerator layout �������������� ������������������������ • The refrigerator is shown in Fig.2-1 and has the following CFC-free, Frost-free, Fast-freeze and Fast-cool options. features: •...
About the Fresh Food Compartment Fig.2-2 It is recommended to leave storage space between the foods for good cold air circulation. The temperatures in the refrigerator are slightly warmer near the top and colder near � the base. Suggestions for storage (Fig.2-2): Eggs, butter, cheese etc.
Bottle Rack Height Adjustment Fig.2-6 Hold both sides of the bottle rack then lift and pull it straight out for cleaning or to change location (Fig.2-7). After cleaning, the bottle rack can be installed in the reverse manner, and the position can be adjusted according to the height of the food to be stored.
Fig.2-11 ArtNo.600-0015 - Fridge freezer control panel � � �� � � � � � A – Quick freeze button, D – Refrigerator temperature display, G – Water filter reset button, B – Freezer temperature adjusting buttons, E – Refrigerator temperature adjusting buttons, H –...
The freezer will remain in this mode for 4 hours. You can press Fig.2-17 the Quick Freeze button after 3 hours if you wish to end the quick-freeze mode early. Water Filter Settings ArtNo.600-0043 - Water supply settings When the water filter indicator light is illuminated this means the water filter should be changed.
Control Centre Power Down After 30 seconds the digital display on the control panel will switch off until such time as the refrigerator is used again. Error Codes In the event of an error occurring, the main control digital display screen will show one of the following codes: F1, F2, F3, F5, F6, Ed, ER, E0, E1, E2.
3. Food Storage Tips Tips on Storing Fresh Food • • Melon, pineapples and bananas can go directly into the Make sure that foods, which have been cooked and freezer after preparing, for storage over a longer period. require chilling, are at room temperature before placing them into the appliance.
Tips on Freezing Food • • As with storing fresh foods, suitable packaging, correct When storing commercially frozen foods, please follow these guidelines: temperature and food hygiene will enhance the quality of the food you are freezing. • Always follow manufacturers’ guidelines for the •...
4. Installation Positioning Your Appliance Fig.4-1 Choosing the Right Location ArtNo.600-0034 - Clearances This appliance should be installed in a room that is dry ���� and well ventilated. To ensure adequate ventilation, the refrigerator should be at least 15 mm clear on all sides from kitchen cabinetry (Fig.4-1).
Refit the cable, pipe, door and top cover in the reverse Fig.4-7 sequence. When removing the hinge and separating it from the door body make sure to support the door to stop it falling forward. Removing the Upper Freezer Drawer Open the drawer as far as possible.
Page 14
Water Supply Connection Fig.4-12 ArtNo.600-0045 - Fitting the water pipe 1 ���������� It is recommended to have this product installed by a qualified technician. Cut the water pipe according to need and avoid bending the water pipe too much. Usually, the pipe length should be less than 5 m.
5. Cleaning and Maintenance Defrosting Fig.5-1 Defrosting is done automatically so there is no need to manually defrost this appliance. DO NOT use mechanical devices to accelerate the defrosting process. Cleaning Disconnect the appliance from the power supply before cleaning.
Changing the Water Filter Fig.5-2 Remove the old filter by turning the filter cartridge handle anti-clockwise (Fig.5-1). The cartridge will eject slightly from the filter housing (Fig.5-2). Air trapped in the system may cause water and the filter cartridge to eject. Use caution when removing. Pull out the cartridge from the filter housing.
When Not in Use Fig.5-6 If you are not using the appliance for an extended length of time, it is recommended that you switch off the electrical supply, empty any food out, clean the inside of the appliance and leave the door ajar. This will save energy, and also prevent ����...
6. Troubleshooting Before calling for service, please first read the following table: this could save you time and money. Problem Cause Solution The temperature is too low The temperature inside the 1.1.1 The temperature inside the 1.1.1.1 Set the temperature in the freezer slightly freezer is too low, with the fresh freezer section is set too low.
Page 19
Problem Cause Solution Water droplets collect in the 3.2.1 Humidity settings are set too 3.2.1.1 It is normal for some wet air to collect inside the lower crisper drawer areas. high. enclosed crisper. To reduce the accumulation of moisture, lower the humidity setting and/or raise the fresh food compartment temperature.
Page 20
Problem Cause Solution Cold water dispenser Cold water not dispensing. 6.1.1 The water supply pipe is not 6.1.1.1 Open the water supply line all the way. open. 6.1.2 6.1.2.1 The water filter is blocked. Replace the water filter. 6.1.3 The water line is blocked. 6.1.3.1 Check that the water tubes are not kinked or restricted.
Page 21
Problem Cause Solution 9.2.3 The doors or drawers are 9.2.3.1 Try to reduce frequency of door or drawer frequently opened and openings. closed. 9.2.4 The control settings in 9.2.4.1 Raise up the compartment temperatures slightly the freezer and fresh food and allow 24 hours to reach new balance.
7. Warranty/After Sales Service If consultation or technical assistance is needed, please provide the local authorised service agent with the purchase invoice and the product code/serial number. The product number/serial number is located inside the refrigerator on the top left-hand side. The 2 years free maintenance for the operation of the appliance started from the date of purchase of this product.
8. Technical Data DocNo.600-0008 - Technical data - DxD 910 INSTALLER: Please leave these instructions with the user. DATA BADGE LOCATION: Left-hand side of the refrigerator compartment. COUNTRY OF DESTINATION: GB/IE/BE/NL/DE/AT/CH/IT/SE Dimensions Depth with open door 1050 ArtNo.600-0044 - DxD dimensions...