Connecting Network Devices; Cabling Guidelines; Connecting To Pcs, Servers, Hubs And Switches - SMC Networks EZ Switch SMCFS801P User Manual

The Power LED indicator turns on green.
2.
C
ONNECTING
This switch is designed to be connected to 10, or 100 Mbps network cards in PCs
and servers, as well as to other switches and hubs.
C G
ABLING UIDELINES
The RJ-45 ports on the switch support automatic MDI/MDI-X pinout
configuration, so you can use standard straight-through twisted-pair cables to
connect to any other network device (PCs, servers, switches, routers, or hubs).
Each device requires an unshielded twisted-pair (UTP) cable with RJ-45
connectors at both ends. Use Category 5 or better for 100BASE-TX connections,
and Category 3 or better for 10BASE-T connections.
C
ONNECTING TO
Attach one end of a twisted-pair cable segment to the device's RJ-45
1.
connector.
Attach the other end of the cable segment to an available port on the
2.
switch.
Make sure each twisted pair cable does not exceed 100 meters (328 ft) in
length.
As each connection is made, the relevant port LED (on the switch)
3.
corresponding to each port will turn on green to indicate that the connection
is valid.
N D
ETWORK
PC , S
S ERVERS
C
HAPTER
EVICES
, H S
UBS AND
– 27 –
| Installing the Switch
3

Connecting Network Devices

WITCHES