Figure 5-9: Static Dhcp Client List; Figure 5-10: Dhcp Client Table - Linksys WTR54GS User Manual

Wireless-G Travel Router with SpeedBooster
Network Setup
The Network Setup section changes the Router's local network settings. Changes to the Router's wireless
network settings are performed through the Wireless tab.
Router IP
IP Address and Subnet Mask. This shows both the Router's IP Address and Subnet Mask, as seen by your
network. The default IP Address is 192.168.16.1, and the default Subnet Mask is 255.255.255.0. In most cases,
keeping the default values will work.
DHCP Server Setting
The settings allow you to configure the Router's Dynamic Host Configuration Protocol (DHCP) server function. The
Router can be used as a DHCP server for your network. A DHCP server automatically assigns an IP address to
each computer on your network. If you choose to enable the Router's DHCP server option, you must make sure
there is no other DHCP server on your network.
DHCP Server. DHCP is enabled by factory default. If you already have a DHCP server on your network, or you
don't want a DHCP server, then select Disabled (no other DHCP features will be available).
Figure 5-10: Static DHCP Client List
Static DHCP. Every time a PC reboots, it is assigned a new local IP address by the Router. If you want a PC to be
assigned the same IP address every time it reboots, then click the Static IP button.
On the DHCP Client List screen, enter the static local IP address in the Assign this IP field, and enter the MAC
address of the PC in the To this MAC field. Then click the Enabled checkbox. When you have finished your entries,
click the Save Settings button to save your changes. Click the Cancel Changes button to cancel your changes.
To exit this screen, click the Close button.
If you want to see a list of DHCP clients, click the DHCP Client Table button. On the DHCP Client Table screen, you
will see a list of DHCP clients with the following information: Client Name, Interface, IP Addresse, and MAC
Addresse. To save the information, select Static DHCP Client List. From the To Sort by drop-down menu, you can
sort the table by Client Name, Interface, IP Address, or MAC Address. To view the most up-to-date information,
click the Refresh button. To exit this screen, click the Close button.
Start IP Address. Enter a value for the DHCP server to start with when issuing IP addresses. Because the
Router's default IP address is 192.168.16.1, the Starting IP Address must be 192.168.16.2 or greater, but smaller
Figure 5-11: DHCP Client Table
than 192.168.16.254. The default Starting IP Address is 192.168.16.100.
Maximum Number of Users. Enter the maximum number of PCs that you want the DHCP server to assign IP
addresses to. This number cannot be greater than 253. The default is 50.
Chapter 5: Configuring the Wireless-G Travel Router with SpeedBooster 15
The Setup Tab - Basic Setup