Resetting The Place Of Destination - Casio EX-Z1000 Service Manual & Parts List

RESETTING THE PLACE OF DESTINATION

When the main PCB is replaced, the setting of the destination will be changed, therefore resetting is required.
However, when the firmware is changed or fixed, the setting of the destination will be held, therefore resetting
is not required.
Use the destination setting script to change the destination flag as instructed below.
1. Have an SD card ready that have a corresponding script (autorun.scp) under the root directory.
2. Insert the SD card in the camera and turn on the power.
The script is located at Qv/soft/Adj_soft/exz1000/Script in the service CD-ROM.
3. After a few seconds, one of the following messages will be shown in the screen.
The system will change the destination flag and turn off the camera automatically.
For North America
For North America
815
Complete
For Europe and UK
For Europe_UK
Complete
For others
else
Complete
4. Remove the SD card from the camera and turn on the power to confirm if the camera is set as you wish
including the number of the menu languages and the scene of the best shot mode.
If there is no problem, the setting is completed.
• Number of menu languages: 10 languages
• eBay scene compatible
• Number of menu languages: 10 languages
• Movie filming time limited
• Number of menu languages: 10 languages
— 18 —