Fuse On The Main Pcb; Resetting The Place Of Destination - Casio EX-Z600 Service Manual & Parts Manual

FU100 ............. This fuse may be broken, if the lens works normally but the LCD does not display when the
power switch is turned on.
FU101 ............. This fuse may be btoken in the following cases.
1. All functions do not work when the power switch is turned on.
2. LED under the shutter button does not light when the battery is loaded.
*Referr to "Printed Circuit Board" on the page 31 for the location of the fuse.

RESETTING THE PLACE OF DESTINATION

When the main PCB is replaced, the setting of the destination will be changed, therefore resetting is required.
However, when the firmware is changed or fixed, the setting of the destination will be held, therefore resetting
is not required.
Use the destination setting script to change the destination flag as instructed below.
1. Have an SD card ready that have a corresponding script (autorun.scp) under the root directory.
2. Insert the SD card in the camera and turn on the power.
The script is located at Qv/soft/Adj_soft/exz600/Script in the service CD-ROM.
3. After a few seconds, one of the following messages will be shown in the screen.
The system will change the destination flag and turn off the camera automatically.
For North America
eBay: On
language: 10
Complete
For others
eBay: Off
language: 10
Complete
4. Remove the SD card from the camera and turn on the power to confirm if the camera is set as you wish
including the number of the menu languages and the scene of the best shot mode.
If there is no problem, the setting is completed.

FUSE ON THE MAIN PCB

• Number of menu languages: 10 languages
• eBay scene compatible
• Number of menu languages: 10 languages
— 18 —