Linksys WPS11 User Manual page 21

Wireless printserver instant wireless series ver. 3

Hide thumbs Also See for WPS11:

Table of Contents

Enlarged version

IPP Client Configuration for Windows 95/98/Millennium/NT 4.0/2000/XP

1. Run the Add IPP Port program entry created by the installation. A screen

like the one shown in Figure 8-1 will be displayed. If you do not see the Add

IPP Port program entry, then click Start. Select Programs and then IPP

Port Monitor. Click Add IPP Port.

1. If Internet access from your location is via a Proxy Server, check Access IPP

Server via Proxy Server, and enter details of your Proxy Server. (This will

be the same as your Browser configuration.)

2. Enter the IP Address or URL of the IPP Server.

3. Click Select Device Port to view the available ports on the IPP Server and

select the appropriate port. A connection to the IPP Server will be estab-

lished at this time.

Instant Wireless™ Series

Figure 8-1

Wireless PrintServer

4. Click Save to create the IPP port on your system. You will see a message

confirming that the port has been created, then Figure 8-2:

Figure 8-2

5. Either select an existing printer to use the new port, and click OK.

Click the Add New Printer button to create a new printer to use the IPP

port. This will start the Add Printer wizard. Follow the prompts to complete

the process. Ensure that the new printer uses the IPP port.

Installation is now complete.

· To create additional IPP Ports, repeat the entire procedure.

· The Proxy Server and other options are set individually for each IPP Port.

Changing the IPP Port Settings

After the IPP port is created, you can reach the Configure IPP Port screen by:

1. Open the Printers folder (Start - Settings - Printers).

2. Right-click the IPP Printer and select Properties.

Table of Contents