Setup; Loose Parts; Removing The Bracket From Rear Tail Wheel; Removing The Deck Banding - Toro Z355 Z-Master Operator's Manual

Setup

Note: Determine the left and right sides of the machine
from the normal operating position.

Loose Parts

Note: Use the chart below to verify all parts have been shipped.
Description
Mulching baffle
Key (1 spare)
Safety booklet
Operator's manual
Engine operator's manual
Parts catalog
Registration card
Removing the bracket from
Rear Tail Wheel
1. Remove locknut from bolt that fastens crate bracket to
tail wheel (Fig. 2).
2. Remove crate bracket from wheel bolt. Install locknut
on to bolt until fork clamps onto spacer (Fig. 2).
1
3
8
7
Figure 2
1. Tail wheel
2. Fork
3. Bolt head
4. Washer
2
4
5
6
m–5268
8
5. Locknut
6. Crate bracket
7. Spacer
8. Shim Washers
Qty. Use
1 For mulching mode
2 Use in the ignition
1
1 Read before operating the machine.
1
1
1 Fill out and return to Toro.

Removing the Deck Banding

Remove any tie down banding that holds deck in place.

Checking the Tire Pressure

Check the air pressure in all tires; refer to Tire Pressure,
page 45.

Activating the Battery

Bulk electrolyte with 1.265 specific gravity must be
purchased from a local battery supply outlet.
Danger
Battery electrolyte contains sulfuric acid which is
a deadly poison and causes severe burns.
• Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and robber gloves to protect
your hands.
•
Fill the battery where clean water is always
available for flushing the skin.
•
Follow all instructions and comply with all
safety messages on the electrolyte container.
1. Remove the battery from the machine. Refer to
Removing the Battery on page 51.
2. Clean the top of the battery with a paper towel.
13