LG LMV1314W Installation Instructions Manual page 10

STEP 3:
PREPARE THE VENT MOTOR
Your microwave oven is shipped with the vent motor assembled for room venting. If you want wall-venting or
roof-vented installation, you must change the fan, as detailed below.
• DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring could
result in electrical shock.
REMOVE THE MOUNING PLATE
1. Remove any shipping materials and parts from inside
the microwave oven.
2. Cover the counter top or cooktop with a thick, protective
covering to protect it from damage and dirt.
See Figure 11.
NOTE: If you have a free-standing range, disconnect it,
move it onto a piece of cardboard or hardboard
and pull it away from the wall, so that you can
get closer to the upper cabinet and back wall for
easier measuring and drilling. Be careful not to
pinch or damage the cord when you push the
range back.
Door
Vent Grille
(2-screw positions
are optional.)
Flat blade
screw driver
3. Remove vent grille by removing two screws on the vent grille.
4. Turn two mounting rods counter clockwise with a flat blade
screwdriver and remove the mounting plate from the unit.
See figure 12.
5. Locate exhaust adaptor, grease filter and handware packet.
6. At this point, remove any adhesive tape (if these is any), on
the exhaust adaptor, the grease filters and the power supply
cord.
ROOM-VENTED INSTALLATION:
Go to "STEP 4: PREPARE THE WALL AND UPPER CABINET
FOR INSTALLATION" located on page 12.
W A R N I N G
ELECTRICAL SHOCK HAZARD!
UNPLUG UNIT BEFORE WORKING ON IT.
Mount-all
Mounting
Rod
Controller
Mounting
Plate
Out Case
Figure 12
Vent motor
- 10 -
A thick, protective
covering
Figure 11
Remove
mounting
plate.
back plate
mount-all
mounting screws
motor
mounting screw
Figure 13
mount-all