Linksys BEFN2PS4 User Manual page 20

of the IP address is set to zero (0). For example, the Router's standard IP
address is 192.168.1.1. Based on this address, the address of the network
to which the Router is connected is 192.168.1, with the last digit (1, in
this case) determining the Router's place on the network. Therefore you
would enter the IP address 192.168.1.0 if you wanted to route to the
Router's entire network, rather than just to the Router.
Network Mask The Network Mask (also known as the Subnet Mask)
determines which portion of an IP address is the network portion, and
which portion is the host portion. In the example above the Network
Mask is 255.255.255.0. This determines (by using the values 255) that the
first three numbers of an network IP address identify this particular net-
work, while the last digit (from 1 to 254) would identify the specific host.
Gateway IP This IP address should be the IP address of the gateway
device that allows for contact between the Router and the remote network
or host.
Hop Count This value gives the number of nodes that a data packet passes
through before reaching its destination. A node is any device
on the network, such as switches, PCs, etc.
Interface This interface tells you whether your network is on the internal
LAN or the WAN, or the external Internet. If you're connecting to a sub-
network, select LAN. If you're connecting to another network through
the Internet, select WAN.
3. Click the Apply button to save your changes.
34
Instant Broadband TM Series EtherFast ® Cable/DSL & Voice Router powered by Net2Phone
DMZ Host
The DMZ Host setting allows one local computer to be exposed to the
Internet to use a special-purpose service such as Internet gaming or video-
conferencing.
To expose one computer, enter the computer's IP address and click the Apply
button. Inactivate DMZ by entering a zero (0). DMZ Host
35