Philips PT927 User Manual page 21

Problem Possible cause
You have not inserted the shaving
heads properly.
The shaver does not The rechargeable battery is empty.
work when I press
the on/off button.
The temperature of the shaver is too
high. In this case, the shaver does not
work.
The shaver is not The cleaning fluid in the cleaning
entirely clean after chamber is soiled.
I clean it in the
Jet Clean System
(PT927CC/
PT923CC only).
The cleaning fluid level is too low. If the
fluid volume in the cleaning chamber
drops below the minimum level during
the cleaning program, the program
aborts.The cleaning symbol and the 'fluid
low' symbol flash at intervals and the
holder returns to its starting position.
You have used another cleaning fluid
than the original Philips cleaning fluid.
You have not closed the locking lever
of the Jet Clean System properly, or
you have not placed the shaver in the
Jet Clean Shaver properly. In these
cases the Jet Clean System starts to
operate, but the cleaning program is
not performed properly.
The Jet Clean The Jet Clean System is not
System (PT927CC/ connected to the mains.
PT923CC
only) does not
work when I press
the on/off button.
Water leaks from This is normal and not dangerous.
the shaver after
cleaning.
Solution
Make sure that the projections of the
shaving heads fit exactly into the recesses
(see section 'Cleaning and maintenance').
Recharge the battery (see chapter 'Charging')
or connect the shaver to the mains.
As soon as the temperature of the shaver
has dropped sufficiently, you can switch on
the shaver again.
Empty and rinse the cleaning chamber
(see chapter 'Cleaning and maintenance').
Refill the cleaning chamber with cleaning
fluid up to the MAX level (see chapter
'Cleaning and maintenance').
Only use Jet Clean solution HQ200.
Place the shaver without protection cap in
the Jet Clean System properly. Close the
locking lever properly.
Put the small plug in the Jet Clean System
and put the adapter in the wall socket.
During rinsing some water may collect
between the power unit and the housing.
After rinsing this water flows out through
the socket. The power unit is completely
watertight so water cannot reach the
electronic parts of the shaver. Your shaver
continues to be absolutely safe.
English
21