Inner Doors; Door Hinge Levers - Bosch SHE4AM12U Repair Instructions

5.9

Inner doors

Inner doors rarely need to be removed for repairs, but need to be
removed to access the lower door seal and door hinge lever.
Tools needed: T20 Torx & #2 Phillips screwdrivers and pliers.
1. Remove outer door – section 5.1.2.1.
2. Remove toe kick – section 5.1.4.1.
3. Remove base insulation (on models with insulation).
4. Disconnect & pull out dishwasher – section 5.1.4.2.
Pull dishwasher out enough to clear hinges.
5. Remove fascia panel – section 5.1.2.2. This eliminates
disconnecting and reconnecting all wire harnesses.
6. If replacing inner door, remove dispenser – section 5.3.1.
7. If the lower door seal sticks to the inner door, separate the
seal from the door by hand (below left).
8. Disconnect door springs from hinge levers (below center).
9. Remove two (2) hinge screws on both sides of inner door
(below). The bottom screws also hold the lower door seal.
702_58300000130262_ara_en_c
5.10

Door hinge levers

Tools needed: T20 Torx & #2 Phillips screwdrivers and pliers.
1. Remove inner door – section 5.9.
2. Remove right hinge ground wire (below left).
3. Pry open hinge bushing latches and lift hinge levers from
hinge plates. Hinge bushings should be replaced after
latches have been pried open.
Page 32 of 50